The Trackless Commercial Finish Mowers
The Trackless front mounted 72" rotary mower is designed for close trimming on both sides with a full width rear discharge. Four large gauge wheels and flexible attaching frame allow accurate cutting on rolling ground. Due to the MT V's hydrostatic transmission, maximum speed of cutting conditions by simply easing up on foot pedal in heavier grass or depressing the pedal further for a faster ground speed where grass is shorter. Articulated steering give the operator precise control in trimming.
The Trackless wing type mower was designed to drastically cut mowing time on large areas such as campuses and parks. Normal undulating ground requires flexibility in mowers to avoid scalping. Trackless solved this problem with a 3 section, front mounted mower comprised of 72" 3-spindle, PTO driven centre section with a hinged hydraulic driven wing on each side. Separate valves control each hydraulic motor and lift cylinder. The MT V has a built-in hydraulic system to power the right wing and an optional pump and valve to power the left wing. Safety switches shut off the wings automatically when raised. For side slope cutting, axle extensions and terra grip turf tires are available.
SPECIFICATIONS
Deck: 72" - 3/16" plate, rear discharge
Spindles: 3 - Timken bearings, greaseable Hydraulic motor drives spindle by V-belt
Blades: 3 - 25" x 2 1/2" x 1/4" high lift
Casters: four swivel with 4" x 10" pneumatic tires
Drive: PTO to right angle gear box, 2 V-belts
Cutting heights: 1 1/2" - 4" in 1/2" increments
Cutting tip speed: 18,500 f.p.m. @ 2200 engine r.p.m.
Wings: 24" or 48"
Casters: 1 - 4" x 10" pneumatic on 24" wing; 3 on 48" wing
Roller: 1 gauge on 24" wing only
Lift cylinder: hydraulic - 2" x 8"
Hinge: compound - 110° ARC





